Ignition Power Transistor

Ignition Power Transistor Inspection:

Ignition Power Transistor Continuity Chart:

NOTE:
An analog-type circuit tester should be used.

1. Connect the negative (-) terminal of the 1.5V power supply to terminal 5 of the [1][2]ignition power transistor; then check whether there is continuity between terminal 5 and terminal 12 when terminal 6 and the positive (+) terminal are connected and disconnected.

NOTE:
Connect the negative (-) probe of the circuit tester to terminal 12.

2. Replace the [1][2]ignition power transistor if there is a malfunction.