Throttle Cable/Linkage: Service and Repair

REMOVAL OF ACCELERATOR CABLE

Accelerator Cable Adjustment Bolts:

1. Loosen the accelerator cable adjusting nut.
2. Disconnect the accelerator cable from the accelerator arm.
3. Remove the accelerator cable.

REMOVAL OF ACCELERATOR PEDAL

Accelerator Cable And Pedal Assembly:

1. Remove the bushing and inner cable from the accelerator arm.
2. Pull the left side of the accelerator pedal toward you, and then remove the accelerator pedal from the accelerator arm.
3. Loosen the bolts of the accelerator arm bracket and remove the assembly.

INSPECTION
1. Check the return spring for deterioration.
2. Check the connection of the bushing to end metal fitting.

INSTALLATION

Accelerator Pedal Assembly, Grease Points:

1. When installing the return spring and accelerator arm, apply multi-purpose grease around each moving point of the accelerator arm.
2. Apply sealant to the bolt mounting hole, and tighten the accelerator arm bracket bolts.
3. Securely install the resin bushing of the accelerator cable on the end of the accelerator arm.

Accelerator Cable Grease Point:

4. Apply multipurpose grease around the cable end.

Accelerator Cable Routing Clamps:

5. Secure the cable with the identification mark at the position shown in the image.