Active Damping Control Module (ADCM)

U0141-00-LOST COMMUNICATION WITH IPM (BCM/TIPM)

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Body Control Module (BCM) is configured correctly.

- Set Condition:
Bus messages not received from the Integrated Power Module (BCM) for approximately two to five seconds.





VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Perform the U0140-00-Lost Communication with (BCM) diagnostic procedure. . U0140

No

- Perform the Stored Lost Communication DTCs diagnostic procedure Stored Lost Communication DTCs.