A/C Low Pressure Cut Off Switch - Removal

REMOVAL

NOTE: Note: It is not necessary to discharge the refrigerant system to replace the A/C low pressure switch.





1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle.
3. Remove the right front wheel.
4. Remove the right inner fender splash shield.
5. Disconnect the wire harness connector (1) from the A/C low pressure switch (2) located on the top of the A/C accumulator (3).
6. Remove the A/C low pressure switch from the A/C accumulator and remove and discard the O-ring seal.