Front Hub and Bearing - Installation

INSTALLATION










CAUTION: A special corrosion prevention gasket (1) must be installed between the hub and bearing and the steering knuckle. The gasket is required to prevent galvanic corrosion between the hub and bearing and the steering knuckle.

1. Install a new corrosion prevention gasket (1) on hub and bearing mounting flange (2).










2. Install hub and bearing (with gasket) in steering knuckle (1). Align holes in corrosion prevention gasket with holes in hub and bearing, and knuckle.
3. Install four hub and bearing mounting bolts (3). Tighten mounting bolts to 61 Nm (45 ft. lbs.).










4. Install ABS wheel speed sensor tone wheel (4). Tighten mounting bolt (4) to 17 Nm (13 ft. lbs.).










5. Install ABS wheel speed sensor head (2) on knuckle (1). Tighten mounting bolt (3) to 11 Nm (100 in. lbs.).

6. Install brake rotor, then caliper. Brake Rotor - Installation
7. Install wheel and tire assembly Tires and Wheels - Installation. Tighten wheel mounting nuts to 135 Nm (100 ft. lbs.).
8. Lower vehicle.