No PCI Loopback

NO PCI LOOPBACK







Theory of Operation

When powered, the Occupant Restraint Controller (ORC) broadcasts messages on the Bus. The ORC on-board diagnostic monitors the Bus for valid ORC messages.

- When Monitored:
With the ignition on.

- Set Condition:
The ORC will set this DTC immediately if valid ORC messages are not detected on the Bus. NOTE: Any Bus Failure may cause a stored code to set.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.
DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read the ORC DTC.

Does the scan tool display an active: NO PCI LOOPBACK DTC?

Yes

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and serious or fatal injury.
WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the ORC.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Restraints System Verification Test.

No

- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Restraint System Intermittent Test.