A/C Switch Fault (Stored)

A/C SWITCH FAULT (STORED)



- When Monitored:
With the ignition on.

- Set Condition:
The A/C mode switch input changes when the switch is pushed down. A stored DTC indicates that the A/C mode switch was stuck in a pushed position for more than 10 minutes, but has since returned to its normal state.





CHECK FOR ACTIVE HVAC DTCS AND SYSTEM TEST FAULT MESSAGES

NOTE: Active DTCs must be resolved before diagnosing stored DTCs.

NOTE: Anytime a DTC becomes active, or an Actuator Circuit Test fault message is displayed, or a Door Recalibration fault message is displayed, proceed to the conclusion question.

1. Turn the ignition on.
2. Turn the mode select control to the panel position.
3. Verify that the blower motor operates correctly in all speeds. Diagnose and repair all blower related faults before proceeding with this test.
4. Turn the blower control to the low speed position.
5. Turn the blend control to the full cold position.
6. Monitor the scan tool for active HVAC DTCs during the following test steps.
7. Press the A/C switch on, wait 30 seconds, and then press it off.
8. Press the EBL switch on, wait 30 seconds, and then press it off.
9. Slowly turn the blend control from full cold to full hot, wait 30 seconds, and then turn it back to full cold.
10. Turn the mode select control to every door position. Leave it in each position for approximately 30 seconds.
11. With the scan tool in HVAC, System Tests, actuate the Actuator Circuit Test.
12. With the scan tool in HVAC, System Tests, actuate the HVAC Door Recalibration Test.

Does the scan tool display any HVAC DTCs or System Test fault messages?

Yes

- Diagnose and repair the DTC(s).
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- No problem found at this time.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.