ORC Messages Not Received

ORC MESSAGES NOT RECEIVED



- When Monitored:
With the ignition on.

- Set Condition:
No BUS messages received from the ORC





1. NO RESPONSE - PCI BUS - ORC
1. Turn the ignition on.
2. With the scan tool, attempt to I/D or communicate with the ORC.

Is there a response from the ORC?

Yes

- Go To 2

No

- Perform the NO RESPONSE FROM OCCUPANT RESTRAINT CONTROLLER MODULE (ORC) diagnostic procedure. No Response From ORC (Occupant Restraint Controller Module)

2. INSTRUMENT CLUSTER
1. With the scan tool, erase the DTC from the Instrument Cluster.
2. Cycle the ignition and wait approximately 1 minute.
3. With the scan tool, read DTCs.

Did this DTC reset?

Yes

- Replace the Instrument Cluster.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- The condition is not present at this time. Monitor scan tool parameters while wiggling the related wire harness. Search for any Technical Service Bulletins (TSB) that may apply. Visually inspect the related wiring harness and connector terminals.
- Perform the BODY VERIFICATION TEST. Body Verification Test