B1B91

B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH







Theory of Operation

When powered, the Occupant Classification module (OCM) sends a test current to the Driver Seat Track Position Sensors terminals. During this test, the sensors discovered are checked for agreement with the pre-programmed configuration of components assigned to the module.

- When Monitored:
The OCM checks for the presence of Driver Seat Track Position Sensor circuits once at every power up, during the initialization process.

- Set Condition:
This DTC sets when the OCM is not configured for a Driver Seat Track Position Sensor and the OCM detects a valid Driver Seat Track Position Sensor present.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

1. VERIFY THAT B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH IS ACTIVE

NOTE: Ensure the battery is fully charged.

1. With the scan tool, read OCM DTC.

Does the scan tool display active: B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH?

Yes

- Go To 2

No

- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Restraints System Verification Test.

2. REPLACE OCM

WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

Repair

- Replace the OCM.
- Perform the OCM REZERO. Testing and Inspection.