Automatic Transmission

INSTALL





1. Align the power steering pump (1) with the mounting holes on the engine.
2. Install the three power steering pump mounting bolts (2) through the access holes in the pulley and tighten the bolts to 28 Nm (21 ft. lbs.).






NOTE: Always use a new O-ring on the end of the pressure hose.

3. Lubricate the new O-ring on the end of the pressure hose with clean power steering fluid.
4. Install the pressure hose (2) to the power steering pump (1) and tighten the pressure hose tube nut to 47 Nm (35 ft. lbs.).





5. Install the supply hose (3) on the power steering pump (1) and securely tighten the hose clamp.






CAUTION: Do not let the tensioner arm snap back to the free arm position, sever damage may occur to the tensioner.

6. Rotate the accessory drive belt tensioner (7) counterclockwise until it contacts its stop and position the accessory drive belt (4) onto the pulleys.





7. Position the air filter assembly into the vehicle.
8. Install the air filter assembly retaining bolt (3) and securely tighten.
9. Connect the make up air hose (2).
10. Install the clean air tube (4) to the throttle body and the air filter assembly and securely tighten the clamps.
11. Connect the intake air temperature (IAT) sensor (5) connector.
12. Install the engine cover (1).





13. Connect the negative battery cable (2).
14. Fill and bleed the power steering system. Power Steering System Bleeding