B229B

B229B-00-PASSIVE ENTRY MODULE (PEM) INTERNAL



- When Monitored:
Whenever the module is awake.

- Set Condition:
This Diagnostic Trouble Code (DTC) sets immediately if the Passive Entry Module internal self-test fails.





VERIFY THAT DTC B229B-00-PASSIVE ENTRY MODULE INTERNAL IS ACTIVE
1. Using the scan tool, record and erase the DTCs.
2. Cycle the ignition switch off then back on.
3. Using the scan tool, read the active DTCs.

Does the DTC B229B-00-PASSIVE ENTRY MODULE INTERNAL reset?

Yes

- Replace the Passive Entry Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.