Returning Vehicle From Long Term Storage

RETURNING VEHICLE FROM LONG TERM STORAGE

For short term storage refer to Owner's Manual.

- Inspect braking discs, light oxidation on stopping surface is acceptable and should diminish as vehicle is driven. If heavy corrosion and pitting is apparent the braking discs would require service before wheels are installed. Testing and Inspection , for proper procedures.
- Install wheels at the same locations from which they were removed. Each wheel hub is marked to indicate proper location.
- Wash preservative oils from engine compartment and undercarriage of vehicle.
- Install fully charged battery. Battery - Installation.
- Perform all time related periodic maintenance described in the maintenance schedules.
- If used, remove desiccant bag from interior of vehicle.
- Clean vehicle as necessary.

It is possible for the clutch disc to adhere to the engine flywheel. The transmission will not go into gear if this condition exists. To correct this condition, lift the rear wheels off the ground and support the vehicle on safety stands. Start the engine with the transmission in fourth gear and hold engine speed at 1200 rpm. Depress clutch and apply the brakes to stop rear wheels. If this procedure is not effective,Testing and Inspection.

- Start engine and verify that oil pressure, generator charging rate and engine coolant temperature are in the normal operating range. Inspect engine and drive line for fluid leaks and abnormal noises, correct any defects that are apparent.
- Pump brake pedal several times to verify proper operation.