Occupant Classification Module - Operation

OPERATION

The microprocessor in the Occupant Classification Module (OCM) contains the Occupant Classification System (OCS) logic circuits. The OCM uses On-Board Diagnostics (OBD) and can communicate with other electronic modules in the vehicle as well as with the diagnostic scan tool using the Controller Area Network (CAN) data bus. This method of communication is also used for OCS diagnosis and testing through the 16-way data link connector located on the driver side lower edge of the instrument panel.

The OCM provides voltage to the flex mat located underneath the passenger seat cushion. The OCM then monitors return inputs from the flex mat on dedicated hard wired data communication circuits. The flex mat inputs allow the OCM to determine whether the passenger seat is occupied and the relative size of the occupant by providing a weight-sensing reference to the load on the seat.

Pre-programmed decision algorithms and OCS calibration allow the OCM microprocessor to determine when passenger airbag protection is appropriate based upon the seat load as signaled by the flex mat. When the programmed conditions are met, the OCM sends the proper electronic occupant classification messages over the CAN data bus VIA the Gateway, to the Occupant Restraint Controller (ORC), and the ORC controls the deployment circuits for the passenger supplemental restraints. On vehicles so equipped, the ORC also provides a control output for the passenger airbag ON/OFF indicator in the instrument panel based upon the electronic occupant classification messages it receives from the OCM.

The OCM microprocessor continuously monitors all of the OCS electrical circuits and components to determine the system readiness. If the OCM detects a monitored system fault, it sets an active and stored Diagnostic Trouble Code (DTC) and sends the appropriate electronic messages to the ORC over the CAN data bus VIA the gateway and back to the ORC on PCI or J1850 messages. Then the ORC sets a DTC and sends messages to control the airbag indicator operation accordingly. An active fault only remains for the duration of the fault, or in some cases for the duration of the current ignition switch cycle, while a stored fault causes a DTC to be stored in memory by the OCM and the ORC. For some DTCs, if a fault does not recur for a number of ignition cycles, the OCM will automatically erase the stored DTC. For other internal faults, the stored DTC is latched forever.

The OCM receives battery current on a fused B(+) circuit through a fuse in Power Distribution Center (PDC) and receives electronic ignition switch status messages indicating the ignition switch position over the CAN data bus. The OCM receives ground through a ground circuit and take out of the body wire harness. These connections allow the OCM to be operational whenever the ignition switch is in the run position.

The most reliable, efficient, and accurate means to diagnose the OCM or the electronic controls and communication related to OCM operation requires the use of a diagnostic scan tool and the appropriate diagnostic information.

WARNING: When replacing the OCM, the OCM Rezero procedure must be performed Testing and Inspection .