Anti-Lock Brake System Module - Installation

INSTALLATION










1. Install CAB onto HCU.
2. Install four CAB mounting bolts (3) and tighten to 2 Nm (17 in. lbs.).
3. Connect pump/motor wiring connector.

CAUTION: Before installing the 24-way connector in the CAB, be sure the seal is properly installed in the connector.

4. Install 24-way connector (2) into socket of CAB as follows:
a. Position 24-way connector in socket of CAB and carefully push it down as far as possible.
b. Once connector is fully seated into CAB socket, push connector lock (1) inward. This pulls connector into socket of CAB and locks it in place.

5. Install access panel in forward portion of left front wheel well.
6. Install tire and wheel assembly Tires and Wheels - Installation. Progressively tighten the wheel mounting nuts in the proper sequence to 135 Nm (100 ft. lbs.).
7. Lower vehicle.
8. Reconnect battery negative (-) terminal.
9. Perform the ABS Verification Test and clear any faults ABS Verification Test.