Ignition Coil - Installation

INSTALLATION





1. Install ignition coil to valve cover. Tighten bolts to 7 Nm (62 in. lbs.).
2. Connect and lock electrical connector at the ignition coil.





3. Install the ignition cable to ignition coil.





4. Clean and apply Mopar(R) Lock & Seal Adhesive to the ignition coil cover bolts.
5. Install the ignition coil cover and tighten the bolts to 12 Nm (106 in. lbs.).
6. Connect the negative battery cable, tighten the nut to 10 Nm (90 in. lbs.).