Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Reach under the instrument panel and disconnect the wire harness lead and connector (3) from the blower motor (4).
3. Disconnect the blower motor air intake duct (2) from the HVAC housing (1).
4. Remove the screws (5) that secure the blower motor to the HVAC housing.
5. Rotate and tilt the blower motor as required and remove the blower motor from the HVAC housing.