Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

P2504






P2504-CHARGING SYSTEM OUTPUT HIGH

For a complete wiring diagram refer to the Wiring Information Electrical Diagrams.

- When Monitored:
The engine is running.

- Set Condition:
The battery sensed voltage is above a certain threshold for a calibrated amount of time. Two Trip Fault. Alternator light will illuminate.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. ACTIVE DTC

NOTE: Inspect the vehicle for aftermarket accessories that may exceed the Generator System output.

NOTE: The battery must be fully charged.

1. Ignition on, engine not running.
2. With a scan tool, select View DTCs.
3. Read and record the related Freeze Frame data for P2504.
4. With a scan tool, erase DTCs.
5. Start the engine.
6. Allow the idle to stabilize.
7. With the scan tool, View DTCs.

Is the DTC Active at this time?

Yes

- Go To 2

No

- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Checking for an Intermittent DTC

2. (A1) BATTERY POSITIVE CIRCUIT VISUAL INSPECTION
1. Turn the ignition off.
2. Inspect the (A1) Battery Positive circuit at Generator Output post for corrosion and looseness.
3. Inspect the Battery + and - cables for corrosion and looseness.
4. Inspect the (A1) Battery Positive circuit at the IPM Power Eyelet for corrosion and looseness.

Were any problems found?

Yes

- Repair and replace as necessary.
- Perform the PCM Verification Test. PCM Verification Test

No

- Go To 3

3. EXCESSIVE RESISTANCE IN THE (A919) BATTERY FEED CIRCUIT

CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install PCM Pinout Box 8815 and PCM Pinout Box Adapter 8815-1 to perform diagnosis.

1. Disconnect the C1 PCM harness connector.
2. Perform a voltage drop test on the (A919) Battery Feed circuit from the appropriate terminal of special tool #8815-1 to the C3 TIPM connector.
3. Using a voltmeter probe the appropriate terminal of special tool #8815-1 with the Negative lead of the voltmeter and probe the (A1) Battery (+) terminal at the IPM with the Positive lead of the voltmeter.

WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.

4. Start the engine
5. Monitor the voltmeter.

Is the voltage above 0.4 of a volt?

Yes

- Repair the excessive resistance in the (A919) Battery Feed circuit between the PCM and IPM.
- Perform the PCM Verification Test. PCM Verification Test

No

- Go To 4

4. POWERTRAIN CONTROL MODULE (PCM)

NOTE: Before continuing, check the Powertrain Control Module (PCM) harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

1. Turn the ignition off.
2. Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the PCM Verification Test. PCM Verification Test

No

- Replace and program the Powertrain Control Module.
- Perform the PCM Verification Test. PCM Verification Test