Timing Component Alignment Marks: Locations

INSTALLATION





1. Install the crankshaft sprocket (1) and position halfway onto the crankshaft.





2. While holding the camshaft phaser in hand, position the timing chain on the camshaft phaser and align the timing marks as shown.





3. While holding the camshaft phaser and timing chain in hand, position the timing chain on the crankshaft sprocket and align the timing mark as shown.





4. Align the slot in the camshaft phaser with the dowel on the camshaft and position the camshaft phaser on the camshaft while sliding the crankshaft sprocket into position.
5. Install the camshaft phaser retaining bolt (1) finger tight.





6. If removed, install the timing chain guide (1) and tighten the bolts (2) to 11 Nm (8 ft. lbs.).





7. If removed, install the timing chain tensioner (2) and tighten the bolts (3) to 11 Nm (8 ft. lbs.).
8. Remove the tensioner pin 8514 (1).





9. Rotate the crankshaft two revolutions and verify the alignment of the timing marks (1, 2). If the timing marks do not line up, remove the camshaft sprocket and realign.