Installation

INSTALLATION

CAUTION: Do not reuse the original brake lamp switch. This switch can only be adjusted once. That is during initial installation of the switch. If the switch is not adjusted properly or has been removed for some service, a new switch must be installed and adjusted.

1. Obtain NEW brake lamp switch. Adjustment lever on new switch should be at a 45° angle from wiring connector. If adjustment lever is parallel with wiring connector, switch has been preset and must be scrapped. DO NOT ATTEMPT TO RESET (OR READJUST) BRAKE LAMP SWITCH.
2. Connect wiring harness to connector on switch.
3. Mount and adjust NEW brake lamp switch using following steps:
a. Install switch in its bracket by aligning the index tab on switch with notch in mounting bracket.
b. When switch body is fully seated in its bracket, rotate switch clockwise approximately 30° to lock switch into place.
c. With brake pedal in fully released position, move adjustment lever on brake lamp switch from 45° angled non-adjusted position, clockwise as shown, until it is parallel with wiring connector. Brake lamp switch is now properly adjusted to vehicle.




4. Reconnect battery negative cable to post on battery.
5. Check stop lamps to verify they are operating properly and not staying on when brake pedal is in released position.
6. Road test vehicle to ensure proper operation of brakes (including ABS) and lamps.