Switch-Interior Door Handle

INTERIOR DOOR HANDLE SWITCH

Any diagnosis of the Power Locks system should begin with the use of a scan tool and the appropriate Diagnostic Procedures.

Refer to the appropriate wiring information.

1. Remove the door trim panel Front Door Trim Panel - Removal.
2. Remove the interior door handle .
3. Use an ohmmeter to test switch resistance between pins.
4. Pull handle.
5. Test resistance between pins. Ohmmeter should show 3.5K Ohm ± 5%.
6. Test resistance between pins while handle is in the unactuated mode. Ohmmeter should show an open condition.
7. If resistance values are not within the parameters, replace the interior door handle.