Procedures

STANDARD PROCEDURE - FUEL TANK CLOSEOUT PANEL

NOTE: This vehicle does not have a Fuel Tank Closeout Panel. To remove the fuel tank a hole will have to be cut in the trunk pan. Use a suitable cutting tool, to cut the trunk pan.

1. Take closeout panel and lay against the front of the trunk pan.
2. Mark the outer edge of the panel.
3. Measure in 1/2 inch from the outline of the closeout panel.

CAUTION: Do not protrude more than 1/2 inch thru the panel. The fuel tank is behind this panel.

4. Cut on the 1/2 inch line marked IN from outline of panel.
5. Cut clearance notch for fuel pump module as needed.
6. Place panel in position and drill pop rivet holes.
INSTALLATION

1. Position closeout panel to vehicle.
2. Apply a bead of Mopar(R) Silicone Rubber Adhesive Sealant, or equivalent, around perimeter of fuel tank closeout panel.
3. Push closeout panel forward into opening in trunk pan.
4. Install pop rivets attaching fuel tank closeout panel to trunk pan.