Bulkhead Quarter Trim Panel

INSTALLATION

NOTE: Convertible bulkhead trim panel shown. Coupe similar.





1. Install the quarter trim support panel and install the nuts.
2. Tighten the nuts to 6 Nm (50 in. lbs.).
3. Install the four front bolts and tighten to 6 Nm (50 in. lbs.).
4. Install the convertible top latch and install the nuts.
5. Tighten the nuts to 10 Nm (85 in. lbs.).
6. Install the trim panel.




7. Route the seat belts through the panel.
8. Install the two screws at the drivers door.
9. Install the sill plate.
10. Install the screw at the rear of the console.
11. Install the sport hoop and install the bolts. (Convertible only)
12. Tighten the bolts to 28 Nm (21 ft. lbs.).
13. Install the sport hoop fastener cover.
14. Install the lower seat belt anchor.
15. Install the two screws at the passenger door.
16. Install the sill plate.
17. Install the screw at the rear of the console.




18. Install the sport hoop and install the bolts.
19. Tighten the bolts to 28 Nm (21 ft. lbs.).
20. Install the sport hoop fastener cover.
21. Install the lower seat belt anchor.