Right Fog Lamp Output Open

RIGHT FOG LAMP OUTPUT OPEN

For a complete wiring diagram Consult Diagrams/Electrical





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, clear all BCM DTC's.
Turn the Fog Lamps on.
With the scan tool, read the DTC information.
Does the scan tool read: Right Fog Lamp Output Open?

Yes

- Go To2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

2. BODY CONTROL MODULE
Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Disconnect the Right Fog Lamp.
Measure the resistance of the Right Fog Lamp Output Circuit.
Is the resistance below 5.0 ohms?

Yes

- Replace the Body Control Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Repair the Right Fog Lamp Output Circuit.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test