Dome Switch Input Short

DOME SWITCH INPUT SHORT

For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
Continuously

- Set Condition:
When the input voltage is less than 0.2 volts for over 10 seconds.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, clear all BCM DTC's.
Turn the Dome Lamps on.
With the scan tool, read the DTC information.
Does the scan tool display: Dome Switch Input Short?

Yes

- Go To2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

2. PANEL LAMPS DIMMER SIGNAL CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the Multifunction Switch harness connector.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Panel Lamps Dimmer Signal Circuit to ground.
Is the resistance below 1000 ohms?

Yes

- Repair the Panel Lamps Dimmer Signal Circuit for a short to ground.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Go To3

3. HEADLAMP SWITCH
Turn the ignition off.
Disconnect the Multifunction Switch harness connector.
Measure the resistance of the Panel Lamps Dimmer Signal Circuit and ground.
Is the resistance below 5.0 ohms?

Yes

- Replace the Multifunction Switch.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Replace the Body Control Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test