0A

0A-LEFT FOG LAMP OUTPUT OPEN





For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
Output is ON to OFF transition.

- Set Condition:
When Output is ON to OFF transition and voltage is detected low at output for greater then 50 micros seconds.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all BCM DTC's.
Turn the Fog Lamps on.
With the Scan Tool, read the DTC information.
Does the Scan Tool read: 0A-Left Fog Lamp Output Open?

Yes

- Go To2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

2. BODY CONTROL MODULE




Turn the ignition off.
Disconnect the Body Control Module C4 harness connector.
Disconnect the Left Fog Lamp.
Measure the resistance of the (L89) Left Fog Lamp Output Circuit.
Is the resistance below 5.0 ohms?

Yes

- Replace the Body Control Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Repair the (L89) Left Fog Lamp Output Circuit.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test