B2714

B2714-FLEX MAT SENSOR MISMATCH

Theory of Operation

When powered, the Occupant Classification Module (OCM) compares the Flex Mat cell configuration to the OCM stored Flex Mat cell configuration.

- When Monitored:
When powered, the Occupant Classification Module (OCM) compares the Flex Mat cell configuration to the Flex Mat cell configuration stored in the OCM memory.

- Set Condition:
This DTC sets if the OCM Flex Mat configuration does not match the Flex Mat connected to the module.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

Diagnostic Test

1. VERIFY COMPLAINT
NOTE: Ensure that the battery is fully charged.

Turn the ignition on.
With the scan tool, read the active OCM DTC.
Does the Scan Tool report the ACTIVE: B2714-FLEX MAT SENSOR MISMATCH?

Yes

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

- Replace the Flex Mat Service Kit.
- Perform *OCM REZERO. Restraint System

No

- Test Complete.
- Perform *RESTRAINTS SYSTEM VERIFICATION TEST. Verification Tests