Totally Integrated Power Module (TIPM)

U0141-LOST COMMUNICATION WITH TOTALLY INTEGRATED POWER MODULE (TIPM)





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

IOD fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the TIPM for approximately 2 to 5 seconds.





1. VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

1. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Go To 2

No

- Refer to the Stored Lost Communication diagnostic procedure. Stored Lost Communication DTCs.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
1. With the scan tool, read all active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes

- Diagnose and repair the DTC.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Go To 3

3. VERIFY THE TIPM IS ACTIVE ON THE BUS
1. Turn the ignition on.
2. With the scan tool, select ECU View.
3. Verify the TIPM is active on the bus.

Is the TIPM active on the bus?

Yes

- Go To 4

No

- Perform the No Response diagnostic procedure. Manufacturer Code Charts

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
1. With the scan tool, select Network View and select Advanced.

Is there more than one module with active DTCs "Logged Against" the TIPM?

Yes

- Replace/update the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Replace/update the module that set this DTC
- Perform the BODY VERIFICATION TEST. Body Verification Test