Upper

UPPER




1. Check to be certain that the eight push-in plastic fasteners (5) are properly installed and in good condition on the inside of the liftgate upper trim panel (3).

2. Position the upper trim panel over the inside of the liftgate (6).

3. Align the two locator pins (2) on the back of the trim panel to the locator holes (1) on the inside of the liftgate.

4. Using hand pressure, press firmly and evenly on the trim panel over each of the eight push-in plastic fastener locations until the fasteners are fully engaged in the holes on the inside of the liftgate.

5. Install and tighten the two screws (6) that secure the lower corners of the upper trim panel to the inside of the liftgate. Tighten the screws to 2 Nm (16 in. lbs.).

6. Reinstall the lower trim panel onto the inside of the liftgate.

7. Close the liftgate.