P0725

P0725-ENGINE SPEED SENSOR CIRCUIT
- When Monitored:
Whenever the engine is running.
- Set Condition:
The Engine RPM is less than 390 or greater than 8000 for more than 2 seconds while the engine is running.

Possible Causes
- ENGINE DTC's PRESENT
- POWERTRAIN CONTROL MODULE

Always perform the 42RLE Pre-Diagnostic Troubleshooting Procedure before proceeding. 42RLE Automatic Transmission

Theory of Operation
The PCM uses a dual port RAM internal to the controller to send the engine speed signal to the Transmission Control System. The calculated engine RPM is compared to a minimum and maximum value. If the PCM interprets this signal to be out of range when the engine is running the code is set. The MIL illuminates after 10 seconds of vehicle operation and the transmission system defaults to Limp-in mode.

Diagnostic Test
1. CONDITION FOR DTC P0725 IS PRESENT
Start the engine.

NOTE: This DTC is not a Transmission Input Speed Sensor DTC.

With the scan tool, view DTC's.
Is the status Active for this DTC or is the STARTS SINCE SET counter set at 0?
YES >>Go To 2
NO >>Go To 3

2. ENGINE DTC's PRESENT
With the scan tool, read Engine DTC's.
Are there any Engine DTC's present?
YES >>Refer to Testing.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
NO >>Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the PCM. With the scan tool PERFORM QUICK LEARN, then program Pinion Factor in the Front Control Module.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests

3. INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set the DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wiring and connectors while checking for shorted and open circuits.
With the scan tool, check the EATX DTC EVENT DATA to help identify the conditions in which the DTC was set.
Were there any problems found?
YES >>Repair as necessary. Perform 42RLE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
NO >>Test Complete.