B2313
B2313-WIPER ON/OFF CONTROL CIRCUIT LOWB2313 - Wiper On/Off Control Circuit Low:
WHEN MONITORED
With the ignition on.
SET CONDITION
When the FCM detects a short/low condition.
POSSIBLE CAUSES
- (A11) Fused B+ circuit open
- Wiper on/off relay
- Front control module
- Integrated power module
Diagnostic test
1. (A11) FUSED B+ CIRCUIT OPEN
NOTE: Check all fuses and circuit breakers before proceeding with the diagnosis of this DTC.
Turn the ignition on.
Remove the Wiper ON/OFF relay.
Measure the voltage at cavity 86 of the Wiper ON/OFF relay.
Q: Is the voltage above 10.0 volts?
YES: Go To 2
NO: Check the (A11) Fused B+ circuit for an open.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
2. WIPER ON/OFF RELAY
Turn the ignition off.
Replace the Wiper ON/OFF relay with and known good relay.
Turn the ignition on.
With the Scan Tool, clear all FCM DTC's.
Turn the Wipers ON then OFF.
With the Scan Tool, read the Wiper DTC's.
Q: Does the Scan Tool read: B2313-WIPER ON/OFF CONTROL CIRCUIT LOW?
YES: Go To 3
NO: Replace the Wiper ON/OFF relay.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
3. INTEGRATED POWER MODULE
Turn the ignition off.
Disconnect the FCM from the IPM.
Measure the voltage on cavity 27 (Wiper ON/OFF Relay Control) of the IPM.
Q: Is the voltage above 10.0 volts?
YES: Replace the FCM.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Replace the IPM.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test