Rear Wiper Motor

REAR WIPER MOTOR

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm (3).




3. Remove the liftgate trim panel.




4. Remove the three mounting fasteners (1).




5. Disconnect the electrical harness connector (5).
6. Separate the wiper motor (3) from the liftgate.




7. Inspect the wiper motor shaft to liftgate seal (1).

INSTALLATION




1. Inspect the shaft-to-liftgate seal (1) in liftgate.




2. If seal is damaged, brittle, or deformed in any way replace. Position shaft seal (1) with the arrow in the UP position.




3. Position wiper motor (3) in liftgate.




4. Install the mounting nuts (1). Torque nuts to 8 N.m (70 in. lbs).







5. Connect the electrical harness connector (5).
6. Install lower liftgate trim panel.




7. Install the rear wiper arm. Torque nut to 18 N.m (13 ft. lbs.).
8. Connect the battery negative cable.