Brake Fluid Pressure Sensor/Switch: Service and Repair

BRAKE PRESSURE SENSOR - SRT8

REMOVAL





1. Disconnect wiring harness connector (4) from pressure sensor (3) below master cylinder (1).
2. Remove pressure sensor (3) from fitting in primary brake tube (2).

INSTALLATION





1. Install pressure sensor (3) into fitting on primary brake tube (2) below master cylinder (1). Tighten switch to 28 Nm (250 inch lbs.) torque.
2. Connect wiring harness connector (4) to pressure sensor (3).





3. Fill master cylinder fluid reservoir (1) with clean, fresh Mopar Brake Fluid or equivalent.
4. Perform Verification Test and clear any faults.