Cable
CABLEREMOVAL
1. Remove the headlamp unit.
2. From the underside of the headlamp unit, remove the six retaining screws (1).
3. Pull the ballast module out of headlamp unit.
4. Disconnect the cable connector (2) Move the lever away or down from the wire of the cable and connector.
5. Remove the rubber boot (1) protecting the lamp/igniter from the elements.
6. Disconnect the electrical cable connector to the lamp/igniter by pulling straight down.
7. Maneuver cable through headlamp unit to separate.
INSTALLATION
1. Maneuver cable through headlamp unit.
2. Connect the cable electrical connectors (2). The connector (2) has a lever that must be locked when connected.
3. From the underside of the headlamp unit, install the six retaining screws (1).
4. Connect the electrical cable connector to the lamp/igniter.
5. Install the rubber boot (1) protecting the lamp/igniter from the elements.
6. Install the headlamp unit.