Oil Cooler: Service and Repair

COOLER-ENGINE OIL

REMOVAL





1. Drain cooling system.
2. Raise vehicle on hoist.
3. Disconnect coolant hoses (2) from oil cooler (1).
4. Remove oil filter (3).
5. Remove oil cooler attaching fastener from center of oil cooler (1).
6. Remove oil cooler (1).

INSTALLATION





1. Position oil cooler to fitting on oil pan.

NOTE: Remove all oil and debris from the seal retainer surface. The cut out section of the oil cooler seal retainer flange (top), must be aligned with the tab on the oil pan. The oil cooler must be prevented from turning during the tightening sequence.

2. Install oil cooler (1) attaching fastener and tighten to 61 Nm (45 ft. lbs.).
3. Install oil filter (3) and tighten to 12 Nm (106 inch lbs.).
4. Connect coolant hoses to oil cooler (2).
5. Fill cooling system.