Front Bumper: Service and Repair
BUMPER-FRONTREMOVAL
NOTE: 300 Shown. Magnum and Charger similar.
1. Remove fascia assembly. Refer to Front Bumper.
2. Drill out the four spot welds (2 per side) between the bumper bracket and rail end cap (1).
3. Remove the eight screws (4 per side) and remove the bumper.
INSTALLATION
NOTE: 300 Shown. Magnum and Charger similar.
1. Position the bumper.
NOTE: It is not necessary to spot weld the bumper back into place.
2. Install the bolts and tighten to 28 N.m (21 ft.lbs.).
3. Install the fascia.