Brake Fluid Pressure Sensor/Switch: Service and Repair

BRAKE PRESSURE SENSOR

REMOVAL





1. Disconnect wiring harness (6) connector from pressure sensor (5).





2. Remove pressure sensor (1) on bottom of master cylinder.

INSTALLATION





1. Install pressure sensor (1) on bottom of master cylinder. Tighten sensor to 28 Nm (250 inch lbs.) torque.





2. Connect wiring harness (6) connector to pressure switch (5).





3. Fill master cylinder fluid reservoir (1) with clean, fresh Mopar� Brake Fluid or equivalent.
4. Perform Verification Test and clear any faults.