Front Tilt Motor

MOTOR-SEAT ADJUSTER

FRONT TILT MOTOR







WARNING: A SEAT STRUCTURE THAT HAS SEEN SIGNIFICANT LOAD MAY HAVE THE LOCKING MECHANISM ACTIVATED AND MAY EXHIBIT THE FOLLOWING SYMPTOMS:
- LOCKING PAWL (2) LOOSE
- LOCKING PAWL (2) ENGAGED INTO THE SEAT FRAME SIDEMEMBER (1)
- HEIGHT ADJUSTER ONLY WORKS ON OUTBOARD SIDE
- BROKEN OR MISSING SHEAR PIN (3)

IF ANY ONE OR MORE OF THESE SYMPTOMS EXIST REPLACE THE HEIGHT ADJUSTER ASSEMBLY. DO NOT ATTEMPT ANY REPAIRS. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY OR DEATH.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the affected seat with the inoperative motor (1).
3. Remove the seat cushion and pan.




4. Disconnect the motor electrical connector.




5. Remove the fasteners holding the motor to the seat adjuster (1).
6. Remove motor from seat adjuster (2).

INSTALLATION




1. Position motor (1) on seat adjuster (2).




2. Install the fasteners (1) holding the motor to the seat adjuster (2). Tighten the screws to 5 N.m (44 in. lbs.).




3. Connect the motor electrical connector.
4. Install the seat cushion.
5. Clip the wire harness to cushion pan.
6. Install the seat assembly.
7. Connect the battery negative cable.
8. Verify normal operation of the power seat assembly.