Positive - Battery to Bulkhead

REMOVAL




1. Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
2. Remove the spare tire cover to gain access to the battery.
3. Disconnect and isolate the battery negative cable (3).
4. Disconnect the battery positive cable (1).




5. Remove the Power Distribution Center (PDC) cover (2).
6. Remove the battery positive cable to rear PDC fastener (3).




7. One at a time, free the battery positive cable from the routing clips located in the rear compartment area.




8. Remove the right, front seat.
9. Remove the right, rear seat cushion. Pull upward at forward edge of each retainer loop of the rear seat cushion to disengage retainer loops from cups in floor.
10. Remove the right, front and rear door sill trim panels.
11. Remove the right, B - pillar lower trim panel.
12. position carpet aside to gain access to the battery positive cable.
13. One at a time, free the battery positive cable from the routing clips located in the rear seat area.




14. Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
15. Remove the battery positive cable to bulkhead fastener.




16. Remove the battery positive cable from the vehicle making note of the cable routing under the floor cross members.

INSTALLATION




1. Position the battery positive cable in the vehicle taking care to route the cable under the floor cross members.




2. Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
3. Install the battery positive cable to bulkhead fastener.
4. Position the bulkhead insulator back to the normal position.




1. One at a time, secure the battery positive cable to the routing clips located in the rear seat area.




2. One at a time, secure the battery positive cable to the routing clips located in the rear compartment area.
3. Position the carpet back to the normal position.
4. Install the right, B - pillar lower trim panel.
5. Install the right, front and rear door sill trim panels.
6. Install the right, rear seat cushion. Engage retainer loops into cup on floor kick up. Push downward at forward edge at each retainer loop of the rear seat cushion to engage retainers.
7. Install the right, front seat.




8. Install the battery positive cable to rear Power Distribution Center (PDC) fastener (3).




9. Install the PDC cover (5).
10. Connect the battery positive cable (1).
11. Connect the battery negative cable (3).
12. Install the spare tire cover.