Right
COVER(S)-CYLINDER HEADREMOVAL
RIGHT
1. Disconnect negative battery (1) cable.
2. Remove upper intake manifold.
3. Disconnect electrical connectors from ignition coils (1) and
4. Disconnect capacitor electrical connector (2).
5. Remove PCV hose from cylinder head cover grommet.
6. Remove ground strap from cylinder head cover stud (1).
7. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
8. Remove fastener attaching ignition coil capacitor.
9. Remove ignition coils.
10. Remove foam insulator (1).
11. Loosen all cylinder head cover fasteners.
NOTE: Cylinder head cover attaching bolts are captured to the cover.
CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover.
12. Remove cylinder head cover.
INSTALLATION
1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1 & 2) as necessary.
2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 Nm (105 inch lbs.).
4. Install ignition coils (1).
5. Install ignition coil capacitor (2) and fastener.
6. Connect ground strap (1) to cylinder head cover stud.
7. Connect PCV hose to cylinder head cover grommet.
8. Connect all electrical connectors and harness clips.
9. Install foam insulator (1)on top of cylinder head cover (2).
10. Install upper intake manifold.
11. Connect negative battery (1) cable.