Oil Supply Line

REMOVAL - LINES AND HOSES





NOTE: For line and hose location refer to (Fig. 19).

OIL SUPPLY LINE
1. Raise vehicle on hoist.





2. Remove elbow support bracket (Fig. 23).





3. Disconnect oil supply line flared fitting from brass fitting at engine block (Fig. 24).
4. Lower vehicle.





5. Disconnect oil supply line flared fitting from brass fitting at turbocharger (Fig. 25).
6. Remove oil supply line.

INSTALLATION - LINES AND HOSES





NOTE: For line and hose location refer to (Fig. 27).

OIL SUPPLY LINE
1. If brass fitting was removed from engine block, apply thread sealer to threads and install. Torque brass fitting to 41 Nm (30 ft. lbs.).
2. Position oil supply line to mounting location.
3. Install NEW washers on banjo fitting of oil supply line (Fig. 26). Hand start banjo bolt at turbocharger (Fig. 25).
4. Raise vehicle on hoist.
5. Hand start flared fitting at engine block (Fig. 25).
6. Torque flared fitting to 31 Nm (23 ft. lbs.) (Fig. 25).
7. Install elbow support bracket (Fig. 23).
8. Lower vehicle.





9. Torque banjo fitting bolt to 37 Nm (27 ft. lbs.) (Fig. 26).