Installation

INSTALLATION
1. Slide transmission back into the clutch and seat against the bell housing.
2. Install upper and lower transmission bolts. Tighten bolts to 41 Nm (30 ft. lbs.).
3. Connect speed sensor, reverse lamp switch and skip shift solenoid main connector at left side frame rail. Connect reverse lamp switch connector on the right side of the transmission.
4. Install the isolator/shifter handle from the shifter tower to the shifter tower with a crow-foot wrench.
5. Install transmission crossmember and mount bolts/nuts. Tighten nuts to 81 Nm (60 ft. lbs.).
6. Remove transmission support.
7. Install hydraulic clutch quick connector to the transmission bell housing.
8. Install drive shaft.

CAUTION: The drive shaft strap bolts must be replaced or cleaned and Loctite@ 242 applied.

CAUTION: Replace drive shaft joint straps whenever they are removed. The straps slightly deform when torqued in place. Reuse of the straps may result in reduced clamp load on the universal joint cap.

9. Install under body stone shield.
10. Lower the vehicle.
11. Connect battery power source.