Removal and Installation

VTSS DISARM SWITCH LOCK CYLINDER

REMOVAL
The rear bulkhead trim panel must be removed to service the VTSS disarm switch lock cylinder.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear bulkhead trim panel. Refer to Body, Interior, Bulkhead Trim Panel, Removal.
3. Disconnect the VTSS Disarm Switch from the back of the lock cylinder.
4. Remove the clip retaining the lock cylinder from the storage box in the rear bulkhead trim panel.
5. Remove lock cylinder from the trim panel.

INSTALLATION
1. Position lock cylinder in trim panel opening.
2. Install the retaining clip.
3. Connect the disarm switch to the back of the cylinder.
4. Install the rear bulkhead trim panel. Refer to Body, Interior, Bulkhead Trim Panel, Installation.
5. Connect the battery negative cable.