Power

REMOVAL





1. Move seat to full forward position.
2. Remove rear inboard bolt attaching seat to floor pan.
3. Remove rear outboard bolts attaching seat to side sill pylon.
4. Position seat in full rearward position.
5. Remove front inboard and outboard bolts attaching seat to floor pan crossmember.
6. Tilt seat rearward and disconnect wire connector to seat belt pretensioner and power seat mechanism.
7. Remove seat from vehicle.

INSTALLATION
1. Adjust seat back to vertical position using either recliner handle.
2. Position seat in vehicle.
3. Tilt seat rearward and connect wire connector to seat belt pretensioner and power seat mechanism.
4. Push downward on seat cushion to ensure that the front mounting brackets are flilly seated to floor pan crossmember.
5. Use power seat switch to move seat to full rearward position.
6. Install and tighten rear outboard bolt attaching seat to side sill pylon.
7. Install and tighten forward outboard bolt attaching seat to crossmember.
8. Install and tighten forward inboard bolt attaching seat to crossmember.
9. Use power seat switch to move seat to flill forward position.
10. Install and tighten rear inboard bolt attaching seat to floor pan.
11. Install and tighten middle outboard bolt attaching seat to side sill pylon.

NOTE:Tighten all seat track retaining bolts to 61 Nm (45 ft. lbs.) torque.