Windshield Washer Pump: Service and Repair

REMOVAL
1. Remove washer reservoir and pump assembly.
2. Notice position of pump, then using a 19 mm (3/4 in.) socket through the liquid filler opening, loosen the pump filter and nut.
3. Disconnect the outside portion of the pump.
4. Remove inner and outer portions of the pump.

Fig. 6 Windshield Washer Reservoir:

INSTALLATION
1. Align outer portion of pump into washer reservoir taking notice of the position of pump.
2. Install rubber grommet into place in bottom of reservoir.
3. Install pump filter and nut using a 19 mm (3/4 in.) socket through the liquid filler opening, tighten to 3 Nm (26 in. lbs.) torque.
4. Align washer reservoir to fender well; tighten the screws to 3 Nm (26 in. lbs.) torque.
5. Install washer pump motor wiring connector and sensor, if equipped.