Ignition Coil: Service and Repair

REMOVAL

Fig. 9 Ignition Coil Location:

The system uses two epoxy filled coil packs mounted on a bracket at the rear of the engine. The coil pack on the left side, contains 3 separate coils and fires cylinders 1, 2, 3, 4, 6, and 7. The coil pack on the right side, contains 2 individual coils and fires cylinders 5, 8, 9, and 10.
1. Remove cowl cover. Refer to the Body.

Fig. 10 Ignition Coil Electrical Connectors:

2. Disconnect electrical connector from coil pack.
3. Remove coil pack mounting screws.
4. Transfer spark plug cables one at a time from original coil pack to the corresponding terminal on the new coil pack.

INSTALLATION
The system uses two epoxy filled coil packs mounted on a bracket at the rear of the engine. The coil pack on the left side, contains 3 separate coils and fires cylinders 1, 2, 3, 4, 6, and 7. The coil pack on the right side, contains 2 individual coils and fires cylinders 5, 8, 9, and 10.
1. Install coil pack. Tighten mounting screws to 11 Nm (95 in. lbs.) torque.

Fig. 11 Ignition Coil Packs:

2. Connect electrical connector to coil pack.
3. Install cowl cover. Refer to the Body.