Headlamp Unit Replacement

REMOVAL
The headlamp module contains the park/turn signal, low and high-beam lamps. When a headlamp module is replaced, the headlamp alignment must be adjusted. Refer to headlamp alignment procedures.
1. Disconnect and isolate the battery negative cable.
2. Remove front bumper fascia to gain access to bottom of headlamp. For Roadster (Refer to FRAMES & BUMPERS/BUMPERS/FRONT FASCIA - REMOVAL) for proper procedures.

Fig. 16 Headlamp Module:

3. Remove nuts holding headlamp to radiator support panel.
4. Remove nut holding headlamp to front frame rail bracket.
5. Disengage wire connector from back of headlamp.
6. Separate headlamp from vehicle.

INSTALLATION
The headlamp module contains the park/turn signal, low and high-beam lamps. When a headlamp module is replaced, the headlamp alignment must be adjusted.
1. Position headlamp to vehicle.
2. Engage wire connector to back of headlamp.
3. Install nut holding headlamp to front frame rail bracket.
4. Install nuts holding headlamp to radiator support panel.
5. Install front bumper fascia. For Roadster (Refer to FRAMES & BUMPERS/BUMPERS/FRONT FASCIA - INSTALLATION) for proper procedures.
6. Connect the battery negative cable.