In Vehicle Service
VALVE SPRING/SEAL SERVICE IN-CAR1. Perform fuel system pressure release procedure before attempting any repairs.
2. Disconnect negative battery cable.
3. Disconnect secondary ignition wires and remove spark plugs.
4. Remove cylinder head cover(s).
5. Using a suitable socket and handle at crank-shaft pulley retaining screw, turn engine until No. 1 piston is at TDC on compression stroke.
6. Remove rocker arms with pivots. The rocker arms should not be disturbed and left on pivots.
7. With air hose attached to spark plug adapter installed in No. 1 spark plug hole, apply 620.5 to 689 kPa (90 to 100 psi) air pressure. This is to hold valves into place while servicing components.
8. Using a suitable tool, compress valve spring and remove retainer valve locks and valve spring.
9. The intake and exhaust valve stem seals should be pushed firmly and squarely over the valve guide using the valve stem as guide. Push seal against top of guide. When installing the valve retainer locks, compress the spring only enough to install the locks.
CAUTION: Do not pinch seal between retainer and top of valve guide.
10. Follow the same procedure on the remaining 9 cylinders. Make sure piston is at TDC on the cylinder the valve spring is being removed.
11. Remove spark plug adapter tool.
12. Install rocker arm and pedestal assemblies. Tighten bolts to 40 Nm (30 ft. lbs.).
13. Install cylinder head covers and tighten bolts to 11 Nm (95 in. lbs.).
14. Install spark plugs and secondary ignition wires.