Park/Turn Signal Lamp Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disengage fastener holding access panel to wheel well panel.
3. Separate access panel from vehicle.
4. Remove wing nuts holding cover to back of headlamp assembly.
5. Separate cover from headlamp.
6. Rotate socket counterclockwise and disengage socket from lamp.

Fig. 26 Park And Turn Signal Lamps:

7. Pull bulb from socket.

INSTALLATION
1. Push bulb into socket.
2. Engage socket to lamp and rotate socket clockwise.
3. Position headlamp cover to headlamp.
4. Install wing nuts holding cover to back of headlamp assembly.
5. Position access panel to vehicle.
6. Engage fastener holding access panel to wheel well panel.
7. Connect the battery negative cable.