Fuel Tank Closeout Panel Replacement

FUEL TANK CLOSEOUT PANEL

NOTE: The Viper Coupe does not have a Fuel Tank Closeout Panel. To remove the fuel tank, a hole will have to be cut in the trunk pan. Refer to the template that comes with the closeout panel and, using a suitable cutting tool, cut the trunk pan. For installation of panel, refer to Closeout Panel Installation Procedures

REMOVAL
1. Take closeout panel and lay against the front of the trunk pan.
2. Mark the outer edge of the panel.
3. Measure in 1 inch from the outline of the closeout panel.

CAUTION: Do not protrude more than 1/2 inch thru the panel. The fuel tank is behind this panel.

4. Cut on the line marked 1 inch IN from outline of panel.
5. Cut clearance notch for fuel pump module as needed.
6. Place panel in position and drill pop rivet holes.

INSTALLATION
1. Position closeout panel to vehicle.
2. Apply a bead of Mopar Silicone Rubber Adhesive Sealant, or equivalent, around perimeter of fuel tank closeout panel.
3. Push closeout panel forward into opening in trunk pan.
4. Install pop rivets attaching fuel tank closeout panel to trunk pan.