Ignition Coil: Service and Repair

Fig 26 Ignition Coil Location:

The system uses two epoxy filled coil packs mounted on a bracket at the rear of the engine (Fig. 26). The coil pack on the left side, contains 3 separate coils and fires cylinders 1, 2, 3, 4, 6, and 7. The coil pack on the right side, contains 2 individual coils and fires cylinders 5, 8, 9, and 10.

REMOVAL
1. Remove cowl cover. Refer to Group 23.

Fig 27 Ignition Coil Electrical Connectors:

Fig 28 Ignition Coil Packs:

2. Disconnect electrical connector from coil pack (Fig. 27).
3. Remove coil pack mounting screws.
4. Transfer spark plug cables one at a time from original coil pack to the corresponding terminal on the new coil pack.

INSTALLATION
1. Install coil pack.
- Tighten mounting screws to 11 Nm (95 in. lbs.) torque.
2. Connect electrical connector to coil pack.
3. Install cowl cover.